Why it happens
DexScreener shows trading pools, not tokens on their own. A token appears once it has a pool on a supported exchange such as Raydium and DexScreener has picked that pool up. A token you have just minted, with no pool, has nothing to show.
Checklist, in order
- Did you create a pool? If not, that is the answer. On CopyFrenzy the pool is created right after minting; if that step failed, retry it (see below).
- How old is the pool? Give a brand-new pool a few minutes to be indexed.
- Are you searching correctly? Use the pool address or the mint address rather than the token name.
- Does the pool exist on-chain? Paste the pool address or your token's mint into Solscan and confirm the pool transaction succeeded.
- Is it paired with SOL on Raydium? Pools on other platforms or with other pairs may look different.
If there's no pool yet
A token without liquidity cannot be traded and will not appear on charts. If the pool step failed after your token was minted (for example your wallet ran low on SOL), the token still exists and you can add liquidity for it again from the launch panel or your Portfolio page.
If the pool exists but the chart is missing
- Wait a little longer and refresh; indexing is not always instant.
- Open the DexScreener link from your launch success panel, which points at your pool directly.
- Confirm you are looking at the right mint address, since copycat tokens can share a name.
- Check the pool on Solscan to be sure it is not an error on your side.
To understand how the pool is built, read Raydium pool creator, and for a full pre-launch checklist see common Solana token launch mistakes.
